Comtech EF Data SDM-300L - Manual (Page 79)

Options SDM-300L Satellite Modem
A–6 Rev. 2
A.2 Options
A summary of the options available for the unit is provided in Table A-2. Contact
Comtech EFData Customer Support for the availabilty status of the the desired option(s).
Table A-2. Options Summary
Option Description & Comments SDM-300L1 SDM-300L2
Install
Option
Single Data/Code Rate Yes Yes FAST
Low Rate Variable ≤
512 Kbit/s Yes Yes FAST
Full Rate Variable QPSK maximum is 4.375 maximum Yes Yes FAST
OQPSK Yes Yes FAST
TX = 70 / 140 MHz, RX = L-Band Yes Not Available Factory
TX = L-Band, RX = L-Band Not Available Yes Factory
RX Only, L-Band Not Available Yes Factory
TX = 50
Ω
IF Impedance Yes Standard Factory
TX = 75
Ω
IF Impedance Standard Not Available Factory
Sequential or Viterbi Codec Modem can be supplied with either:
Viterbi, Sequential or both Yes Yes FAST
TX Reed-Solomon Codec Concatenates with Viterbi or Sequential Yes Yes User
RX Reed-Solomon Codec Concatenates with Viterbi or Sequential Yes Yes User
Asymmetrical Loop Timing (SCT) Yes Yes FAST
Asynchronous (Async/AUPC) Interface
with 50 pin D Connector Requires Overhead Card. Includes
automatic uplink power control (AUPC) Yes Yes User
High Stability Reference. Internal stability
=
±
0.02 PPM, with the ability to drive out
the external reference connector
Yes
(Optional)
Standard Factory
G.703 Interface. Note, For BNC or 15 pin
D interface see UB-530 breakout panels. Requires Overhead Card with 50 pin D
Connector Yes Yes User
37-Pin Female D Connector EIA-422/EIA-449 Interface and
Mil-188-114 Yes Yes User
25-Pin Female D Connector EIA-530 (RS-422), EIA-232 and V.35 Yes Yes User
34-Pin Female V.35 “Winchester” Connector with V.35 Yes Yes User
50-Pin Female D Connector for use
Without Overhead card. Inlcudes EIA-422, EIA-232, and V.35
Use with redundancy switches Yes Yes User
Primary Power: Auto-ranging AC 85 to
264 VAC Yes Yes Factory
Future Or Not Available
-30 to -5 dBm IF output (low power) Output 2nd Harmonics:
<
45 dBc at data rates
<
64 kbit/s
<
50 dBc at data rates
≥
64 kbit/s
Not Available Not Available Factory
8PSK, 2/3 rate, IESS-310 Requires Viterbi and Reed-Solomon
Codec Not Available Not Available User
8PSK, 2/3 rate, EFD Mode Requires Viterbi Codec Not Available Not Available User
IBS and IDR Interface Requires Overhead Card Not Available Not Available User
Drop & Insert Interface Requires Overhead Card Not Available Not Available User
Flex Mux Not Available Not Available User
Mux Available in: 4-Channel
8-Channel
Not Available Not Available User
Primary Power: 48 VDC Yes (Future) Yes (Future) Factory
ODU DC Power: 15V, 24V, 28V or 48V.
Primary input = AC Only 3 Amps maximum or less depending upon
power supply. Not Available Yes
(Future)
Factory