Comtech EF Data CMR-5940 Manual - Manual (Page 32)

CMR-5940 Digicast Media Router PID Filter RS-422 Revision A
Device Management via User Interfaces MN/PIDFILDC4.IOM
4.2.6 Unicast Routing Configuration
Figure 4-8. Unicast Routing Configuration page
The Unicast Routing Configuration page addresses the CMR-5940’s configuration for
handling Unicast traffic over the transport stream. This feature is only used in the
MPE/IP configuration.
Allow Unicast
Selects whether the CMR-5940 will support the routing of Unicast traffic.
Route unknown to default gateway
If an Address Resolution Protocol (ARP) cannot be achieved, then incoming
Unicast is directed to the configured default gateway.
Filter on TSD MAC (MPE/IP)
Allows the CMR-5940 to route only Unicast that is specifically destined to this
unit. The MAC address in the MPE header must exactly match the configured
TSD MAC field.
TSD MAC (MPE/IP
The hardware Media Access Control (MAC) address assigned for Unicast
operation.
Login Required
A user name and password are required to make any changes to the CMR-5940
configuration.
4-8