Comtech EF Data CiM Quick-Start Guide - Manual (Page 16)

CiM Quick Start Guide Rev. 1
Operation CD/CIMQSTART.IOM
6
1.7.4 C
I
M 2 C
ONFIGURATION
Disconnect RJ-11 end of the console cable from CiM 1 and connect it to CiM 2.
1.7.4.1 S
ETTING
IP A
DDRESS
(
ES
)
Step Description
1 From the Main Menu select Network Configuration sub-menu.
2 Set Ethernet IP Address to 172.17.10.10.
3 Set Subnet Prefix Length to 24.
4 Set HDLC IP Address to 10.1.1.2.
The other parameters can be left to their factory default settings.
At this point you should be able to ping CiM 2 from PC 2:
5 ping 172.17.10.10
6 ping 10.1.1.2
1.7.4.2 R
OUTE
T
ABLE
Step Description
1 From Transmitter Configuration, sub-menu select Route Table sub-menu.
2 Enter 1 to configure the first route
3 Enter a suitable name
4 Set IP Address to 172.16.10.0
5 Set Number of Subnet Bits to 24
6 Enter the next hop IP address which is CiM 1’s HDLC IP Address, 10.1.1.1
1.7.4.3 S
AVE
C
ONFIGURATION
Save parameters to permanent storage.