Compuprint SP40 - Manual (Page 34)

30
Setup Parameter Values Description
automatic type is selected between serial and parallel by the printer
depending on data coming from host.
*It is reported if the LAN option is installed. For details refer to the
LAN manual
IBM FINANCIAL no,
honorCTS,
ignoreCTS
Disables the Financial protocol if IBM 4722 or IBM 9068
emulation is selected
Enables the IBM FINANCIAL for the IBM 4722 and 9068
protocols. Considers (handles) or ignores the CTS signal
received from host for the control of the data stream from host.
INPUT BUFFER 1 Kb, 8 Kb, 16 Kb, 32 Kb,
64 Kb Selects the buffer size.
When the 'financial' interface is selected, this setting is ignored.
IGNORE PE enabled, disabled Selects whether the printer signals the paper empty condition
(
disabled) or not (enabled) on the busy line.
AUTOFEED SIGNAL disabled, enabled The parallel interface uses ( enabled) or does not use
( disabled) the AUTOFEED signal.
SLCT-IN SIGNAL disabled, enabled The parallel interface uses ( enabled) or does not use
( disabled) the SELECT-IN signal.
BUFFER CONTROL DTR+SRTS, SRTS,
XON/XOFF, ETX/ACK,
XON/XOFF+DTR+SRTS
Selection of the buffer protocol. When the 'financial' interface is
selected, this setting is ignored.
ROBUST XON enabled, disabled Perform the Robust XON ( enabled) or not (disabled).
WORD LENGTH 7 bit, 8 bit Sets the number of the data bits. When the 'financial' interface is
selected, this value is always set to 8 bits.
BAUD RATE 1200 – 38400 bps Sets the data transfer rate.
PARITY BIT even, odd, space, mark, Selects the parity control for the data.