Code CR2 User Manual
Page 42
C001537_18_CR2_User_Manual
36
Save Settings
2.11.1 - Continuous Scan - Sleep Time Out
Scan one of the codes below to set the amount of time a cabled CR2 will operate in continuous scan mode, without a
decode, before entering sleep mode:
Cabled - 2 hours (Default)
Cabled - Always
Scan one of the codes below to set the amount of time an uncabled CR2 will operate in continuous scan mode before
entering sleep mode:
Uncabled - 5 minutes (Default)
Uncabled - 15 Minutes
Uncabled - 30 Minutes
Note: This function is only recommended for short term use because of battery consumption.
2.11.2 - Continuous Scan - Trigger Delays
Scan the following codes to set delay time between scans:
0 Seconds (Default)
1 Second
3 Seconds
2.11.3 - Continuous Scan - Duplicate Scan Delay
Scan the following codes to set the delay time for reading duplicate codes:
0 Seconds (Default)
1 Second
3 Seconds
2.11 - Continuous Scan Settings
2.12 - Motion Detection Scan Settings
Scan the following codes to set the reader to read when it detects motion in its scanning zone.
On
Off (Default)