D-Link DES-5016 - Manual (Page 90)

Fast Ethernet Switching System User’s Guide
Appendix A
82
Appendix A
DES-5016 Technical Specifications
Switch Specifications
•
Complies with IEEE 802.3 CSMA/CD 10/100-TX, 100BASE-FX and
1000BASE-SX
•
Complies with IEEE 802.1d Spanning Tree
•
Switched IEEE 802.3 MAC layer frame size: 64-1518
•
NWAY Auto-negotiation for each 10/100-TX network port providing auto-
detection of connected cable type, auto-sensing of full and half duplex signaling
and auto-configuration
•
Cut-Through and Store-and-Forward switching for reliable error-free packet
transfers
•
Native SNMP management support with Ethernet MIB II (RFC 1213) and bridge
MIB (RFC 1493), RMON MIB (RFC-1757)
•
8,192 maximum entries for MAC address Table
•
Comprehensive LED indicators display of the system/ port status
•
512KB EEPROM (flash memory) for firmware upgrade
•
RS-232 (DB-9) port for Out-of-Band management (asynchronous, 8-bit data, 1
stop bit, no parity, 19.2 K baud)
•
Rack mountable (Fits standard 2.5 U EIA 19” rack)
•
8 port 10/100-TX module with built-in support of RMON and VLAN
•
Supports Trunking Group
•
Eight port fiber optic (FX) module with built-in support of RMON and VLAN
•
Two port fiber optic (FX) expansion module with built-in support of RMON and
VLAN
•
One port gigabit (SX) expansion module with built-in support of RMON and
VLAN
Port Specifications
•
RJ-45 ports for Cat 3, 4, and 5 UTP cable (Cat. 5 req. for 10/100-TX)
•
10, 100, 1000 Mbps data transfer rate
•
NWAY Auto-negotiation for all 10/100-TX ports