Caple CM107 - Manual (Page 5)

5
EN 2/INSTALLING YOUR APPLIANCE
Warning:
Ensure that your appliance has not
suffered any damage during transport
(deformed seal or door, etc...). If you see any
kind of damage, before doing anything else,
contact your retailer.
In order to easily locate the reference
information for your appliance, we
recommend that you note these data on the
“After-Sales Service Department and
Customer Relations” page.
Ensure that:
- The electrical installation has sufficient
voltage.
- The electrical wires are in good condition.
- The diameter of the wires complies with the
installation requirements.
- Your electrical installation is equipped with
16-ampere thermal-sensitive protection.
In case of doubt, consult your electrician-
installer.
The electrical connections are made before
the appliance is installed in its housing.
Electrical safety must be provided by a
correct build-in. During installation and
maintenance operations, the appliance must
be unplugged from the electrical grid; fuses
must be cut off or removed.
The oven must be connected with a power
cable (standardized) with three 1.5 mm 2
conductors (1 ph + 1 N + ground) that must
be connected to a monophase 220-240 V
network via a CEI 60083 standardised
receptacle (1 ph + 1 N + ground lead) or in
accordance with installation rules. The safety
wire (green-yellow) is connected to the
appliance’s terminal and must be
connected to the ground lead of the electrical
set-up.
In the case of connections with an electric
receptacle, it must remain accessible after
installation of the appliance.
The oven’s neutral conductor (blue wire)
must be connected to the network’s neutral
conductor.
In your electrical installation, allow for a user-
accessible device that must be able to
separate the appliance from the main power
supply and whose contact opening is at least
3 mm above all the terminals.
If the power cable is damaged, it should be
replaced by the manufacturer, its after-sales
service department or by a qualified person
to avoid danger.
Warning:
We cannot be held responsible for any
accident resulting from an inexistent,
defective or incorrect ground lead.
If the oven malfunctions in any way, unplug
the appliance or remove the relevant fuse at
the oven’s connection lead-in.
•BEFORE HOOK-UP
•ELECTRICAL CONNECTION