beautypg.com

Using the power levels •programming – Caple CM107 User Manual

Page 13

background image

EN

4/USING YOUR APPLIANCE

13

Power level

Use

1000 W/900W

Quickly reheating beverages, water and dishes containing a large
volume of liquid.
Cooking dishes containing alot of water (soups, sauces,
tomatoes, etc.).

800 W/700W

Cooking fresh or frozen vegetables.

600 W

Melting chocolate.

500 W

Cooking fish and seafood. Reheating on two levels.
Cooking dried beans at low heat. Reheating or cooking
fragile, egg-based dishes.

400 W/300W

Low-heat cooking of dairy products, jams.

200 W

Manual defrosting. Softening butter, ice cream.

100 W

Defrosting pastries containing cream.

MICROWAVE OVEN OUTPUT: 1000 W

Your appliance is now hooked up and the correct time is set.

Open the door using the handle. Place the food in the appliance, then close the door.

If the door is not closed properly, the appliance will not function.

Opening the door during operation does not cancel the current programme; it merely

suspends it. To restart the oven, close the door and press the START/STOP touch

control.
If programming is not followed by any action after one minute, three beeps are

sounded to invite you to start or modify the programme. If you do not give any

instructions, after one minute the settings are cancelled and you will have to

reprogramme.
Press the START/STOP touch control when the door is closed to interrupt the

programme.
To cancel the programme, open the door and press START/STOP or press and hold

the START/STOP touch control for two seconds with the door closed.
To enter a second programme after the end of the first one, open the door and

close it.
Three beeps are sounded to indicate the end of each programme and the time is

again displayed in the display panel.
If the door is left open, the light turns off after 10 minutes.

To eliminate moisture, your appliance is equipped with a delayed ventilation function.

The oven’s ventilation continues to function after the end of the programme. It will

stop automatically.

•USING THE POWER LEVELS

•PROGRAMMING