BUG-O Systems BGW-5000 - Manual (Page 7)

7
7. Equipment that is classified as internal combustion engines
A. The engine should be shut down before the troubleshooting and maintenances unless it needs to run
during the maintenances.
B. The engine should be operated in an open place with good ventilation conditions, or else the waste gas
must be exhausted outdoor.
C. Refueling is forbidden near the welding arc or when the engine is running. The engine should be
stopped and not refueled until it cools down, avoiding spilling fuel and contact to the hot parts of the
engine as it may cause a fire. If fuel spills out, then the engine can be started only when the spill is
wiped clean.
D. Keep the safety covers and devices at appropriate places and maintenance should be conducted on
time. During the starting, operation and maintenance of the equipment, hair, clothes and tools should be
kept away from V-belts, gears, fans and other moving parts.
E. Sometimes, the protection cover must be disassembled to facilitate the maintenance. Keep in mind that
the protection cover can be disassembled if it is necessary and it should be replaced quickly after the
maintenance. In addition, it is necessary to be cautious when you work near moving parts.
F. Hands are forbidden to be near the fan. When the engine is running, it is forbidden to push the control
lever of the gas throttle forcibly regardless of the speed governor or the idler wheel.
G. When the engine or the welding power source is rotated during maintenance, connections of the
sparkplug, the ignition distributor, the electromagnetic generator and others must be disconnected to
prevent the accidental starting of the gasoline engine.
H. To avoid scalds, the radiator cap is prohibited to be opened when the engine is still hot.