BUG-O Systems BGW-5000 User Manual
Page 21
21
4.1.5 Adjust drive wheels of the travel mechanism to the diameters of the tank, then lock them into position.
Fig. Square tube mechanism
4.1.6 Once the main frame is setup correctly, mount the cable hanger (1). Safety hand rail (2),
electric flux winch (3) and flux lifting post (4), on the frame roof.
This manual is related to the following products:
See also other documents in the category BUG-O Systems Equipment:
- HOB-O (18 pages)
- Side Beam System (17 pages)
- Flame Cutting (34 pages)
- Trac-Bug (21 pages)
- Programmable Shape Machine (31 pages)
- Programmable Shape Machine (22 pages)
- K-BUG 1200 (21 pages)
- Programmable Gantry System (36 pages)
- CWP-5 (40 pages)
- CWP-7 (41 pages)
- CWP-11 (47 pages)
- CWP-18 (41 pages)
- CB-1P (37 pages)
- CB-3 (30 pages)
- CW-5 (34 pages)
- CWE-5 (40 pages)
- CW-5AX (41 pages)
- CW-7 (43 pages)
- Elbow Cutters 3rd Axis (14 pages)
- CW-11 (46 pages)
- CW-18 (41 pages)
- SE-4PD (48 pages)
- SE-4PTD (40 pages)
- SE-4PD (43 pages)
- FTS-1025 (17 pages)
- BVW-1000 (26 pages)
- AGS-4100 (46 pages)
- Standalone CDS Linear Weavers (20 pages)
- Standalone Pendulum Weavers (18 pages)
- DC IV v.2 (22 pages)
- UNI-BUG II (21 pages)
- PBM-2002 (17 pages)
- BEAM BUG III (23 pages)
- SPB-3000 (26 pages)
- Speed Weaver II (14 pages)
- UNI-BUG III (44 pages)
- CAS-2050 (20 pages)
- BUG-6554 (32 pages)
- CAS-2060 (20 pages)
- BUG-9874 (12 pages)
- STW-2000 (32 pages)
- STW-3000 (26 pages)
- Stiffener Welder (29 pages)
- MDS-1004 (14 pages)