BUG-O Systems CB-1P - Manual (Page 5)

5
INTRODUCTION
The CB-1P (CBO-1020) Plasma Circle Burner was designed for plasma bevel cutting of one to
twelve inch diameter holes and will cut beveled holes in light wall pipe or vessels with wall thick-
ness up to 5/16" (7 mm). An automatic rise and fall cam controls the torch position for saddle cut
holes up to 2/3 of work diameter. The cables and air hoses supplying the unit pass through slip
rings and O-rings enabling the machine to operate continuously in either direction without cable
or hose wrap up. The CB-1P (CBO-1020) Plasma Circle Burner is supplied with a Victor / Thermal
Dynamics (CutMaster 82) plasma power source, 180 degree plasma machine torch and 50' (15 m)
control cable / torch lead. The CB-1P (CBO-1020) Plasma Circle Burner requires both 220/50-60/1
and 120/50-60/1 to operate. The unit must be mounted on a carriage or fixture.
FEATURES
• 1/12 HP P.M. motor and rotational speed control
• 180 degree plasma machine torch
• 50 ft. (15 m) control cable / torch lead
• Adjustable vertical and horizontal torch positioning system
• Rise and fall cam assembly with 5" (125 mm) of travel
• Brushes and collector rings for plasma current, rated at 200 AMPS
• Brushes and collector rings for all controls, eliminates cable and hose wrap
• Plasma cutting power supply, CutMaster 82 Plus with duty cycles of 65% at 60 AMPS and
100% at 50 AMPS
• Rotation speed and directional controls
• Manual / Off / Automatic control switch