BUG-O Systems CB-1P - Manual (Page 34)

34
PREVENTIVE MAINTENANCE FOR CB-1P PLASMA CIRCLE BURNER
CAUTION: Make sure the input power at the power source is turned off and the high and low
frequency power cables, and the 50' control cable (Items # 2, 3,10, on the CB-1P Electrical Wir-
ing Diagram) are disconnected from the circle burner prior to working inside the machine.
POWER SUPPLY: Refer to the Thermal Dynamics Cut Master 82 Plus Plasma Cutting Power
Supply operating manual # 0-4979 supplied with this machine for general maintenance proce-
dures and replacement parts.
PLASMA TORCH: Refer to the Thermal Dynamics Plasma Cutting Torch model PCM-102 ma-
chine torch instruction manual # 0-2818 supplied with this machine for general maintenance
procedures and replacement parts.
AFTER DAILY USE:
Refer to CB-1P Exploded View / Parts List. (Page 13)
Racking System Item # 1: Inspect gear rack; hardened ways and wheels (remove all dirt,
grease, and rust). Check hardened ways for nicks and replace if necessary. Lubricate with a dry
spray lubricant. Adjust wheels for snug fit and smooth operation. Lubricate racker pinion with a
dry Teflon or graphite spray lubricant.
Small Vertical Racker Item # 2: Inspect wheels (remove all dirt, grease, and rust). Adjust
wheels for snug fit and smooth operation. Lubricate racker pinion and wheels with a dry Teflon or
graphite spray lubricant.
Slide Bar Mounting Assembly Item # 10: Inspect hardened ways (remove all dirt, grease, and
rust). Check hardened ways for nicks and replace if necessary.
Refer to CB-1P Electrical Wiring Diagram. (Page 14)
Control Cable Item # 10: Inspect cable connector to make sure threads are not stripped and
that the connector is not cracked. Check the cable for cuts, missing insulation, and burn spots
replace if necessary.
CB-1P Collector Ring Item # 9: Inspect cable connector to make sure threads are not stripped
and that the connector is not cracked. Ensure that the connector is fastened properly to the large
aluminum gear (item # 30, page 12).