Bronkhorst E-7000 - Manual (Page 39)

BRONKHORST HIGH-TECH B.V.
9.17.004 page 39
FLOW-BUS
4 Operation of digital (FLOW-BUS) instruments
digital instrument
4.1 General information
Before operating your system be sure that it is setup to readout and control digital (FLOW-BUS) instruments.
Check: model configuration; sensor output signal. The code should be “R”
Use 'cursor' keys to scroll through the menu-structure and to select the required menu level.
The 'enter' key is used to acknowledge a selected setting and to enter a edited value and/or text.
Editing can be performed by using the 'cursor' keys to select the character to be edited (
←
/
→
) and to scroll
through the available character set or units (
↑
/
↓
).
After power-up the display will show the usual start-up sequence for some seconds.