Dixon 8000G Series - Manual (Page 17)

17
CONTROLS
MOWER BLADE SWITCH:
To engage blades: pull up on switch
To disengage blades: push down
IGNITION SWITCH:
•
Turn to start position to crank engine.
Release when it starts.
•
For headlights - rotate switch one
notch counter-clockwise from run.
Note: Remove key when mower is
not in use.
CHOKE CONTROL LEVER:
• Located on the control panel to the
operator’s right.
THROTTLE CONTROL LEVER:
•
Located on control panel to operator’s right.
•
Controls engine speed.
•
While mowing, throttle control should be set to MAXIMUM or wide
open setting to insure adequate cooling of the engine and to
maintain mower deck blade speed.
CIRCUIT BREAKER:
•
If circuit breaker pops up, it disconnects the power. Wait 2 minutes
and push to reset.
•
If it pops up again, there is a short circuit. Stop and find fault or
contact your dealer.