Dixon 8000G Series - Manual (Page 13)

13
SPECIFICATIONS
8000 Series (Gas Version)
CHASSIS: 11 GA - rectangular tube, 7 GA reinforcement
SEAT: Designed for operator comfort with padded back & arm
rests. Seat is adjustable fore & aft. Seat back tilts. Mounted
on operator suspension system with damper.
MOWER DECK: 2 decks are available. Both decks are made of 10 GA
fabricated welded construction with 1/4 " reinforcement
plate. 3 blades combine for either a 60" or 72" cut width. Deep
deck with discharge tunnel. Cut height approximately 1.5" to
6" via 10 position lift handle.
BLADE DRIVE: "V" Belt with Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDP-
10A pump and White CE wheel motor.
ENGINE: 25HP Kohler Command, 4-Cycle, V-Configuration, Overhead
Valve, Air-Cooled, Gasoline, Horizontal Shaft, Aluminum Head
and Crankcase with Cast Iron Liners, Full Pressure
Lubrication/Full Flow Filter, Pulse-type Fuel Pump, Fixed Jet
Carburetor, Electronic Ignition, In-Line Fuel Filter, Dual Element
Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on
parking brake, blade drive clutch and control levers.
TIRES: Front 13-6.5x6
Rear 23-10.5x12
RECOMMENDED Front 16-20 lbs.
TIRE PRESSURE: Rear 8-14 lbs.
CAPACITIES: Fuel - 11 gallons (approx)
Hydrostat oil system - 4 quart with in-line 40 micron filter
Hydrostat oil recommendation - SAE 20W50 motor oil
Engine - 2 quart. SAE 10W30 motor oil
DIMENSIONS: Width 73.5"(60" Deck), 85.5"(72" Deck)
Height 54"
Length 87"
Weight 1020 lbs.(60" Deck), 1054 lbs.(72" Deck)
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.