Bolide SVR9000D - Manual (Page 28)

User Manual
27
Latch time: you can set how long the buzzer will sound when object move is detected (10s, 20, 40s, 60s);
Show Message: You can set show message on the screen when motion alarm is detected.
Buzzer time: you can set how long the buzzer will sound when motion is detected (10s, 20, 40s, 60s);
Send Email：Allows you set the alarm images is issued to a specified email.
Full screen Alarm: The function is defaulted to “On". When the motion is detected, the corresponding
channel will be switched to the full screen mode.
Record Channel: the record channel will be activated when the object move is detected.
Post Recording: you can set how long alarm record will last when alarm ends (30s, 1minute，2minute，
5minute).
5.3.5.2 Alarm Set
Click [Main Menu Alarm Alarm] to enter into the below window shown as Picture 5-39. Now you can
perform alarm set based on different status. Details please refer to List 5-1.
No: allow you select one desired channel
I/O Status: allows you select the three options – NO (Normal Open), NC (Normal Close) and OFF. Set to “Normal
Open”, I/O status Alarm will be activated while sensor is ON; set to “Normal Close”, I/O status alarm will be
activated while sensor is OFF; set to “OFF”, I/O status alarm will not be triggered.
Alarm out: allow you connect external alarm sensor.
Latch time: you can set how long the buzzer will sound when external sensor alarm is detected (10s, 20, 40s, 60s);
Show Message: You can set show message on the screen when sensor alarm is detected.
Buzzer time: you can set how long the buzzer will sound when sensor alarm is detected (Off, 10s, 20, 40s, 60s);
Send Email：Allows you set the alarm images is issued to a specified email.
Full screen Alarm: The function is defaulted to “On". When the motion detection or external alarm is
triggered, the corresponding channel will be switched to the full screen mode.
Record Channel: allow you select channels you want to record.
Post Recording: you can set how long alarm record will last when alarm ends (30s, 1minute，2minute，
5minute);
Copy: allow you copy current channel parameters to any
other channel or all channels.
The channel will be separated into a 15X12grids (PAL
mode) or 15X10grids (NTSC mode). When any object moves
into the motion detection area, and the area where the object is
located is displayed in red and motion detection will be
triggered. In the semi-transparent area the motion detection is
not activated.
Picture 5-38
Picture 5-39 4CH 8CH