Bluelab Dosetronic Peridoser Kit - Manual (Page 16)

12
Version P1.3 : 151012
Bluelab Dosetr
onic P
eridoser Kit
Bluelab Corporation Limited
Po w e r
pH Dosing system
Temperature
Conductivity
pH ATC Alarm
Power Input DC INPUT: 5V --- 3A
Temperature Power Out Temperature Power In
2.8 Heater/Cooler Setup
The Dosetronic can control either air or water
temperature via an external heater/cooler.
These sockets allow the Dosetronic to switch
the heater or cooler on and off.
The heater/cooler works at defi ned intervals.
These intervals can be programmed in the
“On” and “Off Times” found in the Mode
menu. Instructions for this can be found on
page 23 and 24.
Note: Do not connect the “Temperature
Power In” to power source until you have
programmed the Dosetronic Controller.
Temperature Power In
This socket provides external power for the
heater or cooler.
Temperature Power Out
This socket is where you plug in a heater or
cooler.
Temperature
Power In
Temperature
Power Out
Temperature
Power In
Temperature
Power Out
2
Or
Note: You must place temperature probe in what you are controlling