Bluelab Dosetronic Peridoser Kit - Manual (Page 13)

9
Version P1.3 : 151012
Bluelab Dosetr
onic P
eridoser Kit
Bluelab Corporation Limited Bluelab Corporation Limited
2
2.5 Mount Dosetronic Control Case
The Dosetronic has an indoor, splash-proof case and
should be installed in a pump room or shed. It is
designed for use with a sample pot that is fi lled with
water from the nutrient mixing tank.
Conductivity, temperature and pH measurement probes
that connect to the Dosetronic are placed inside it,
therefore the Dosetronic needs to be installed close to
the sample pot to enable the probes to reach.
Steps
1. Locate area
Find appropriate fl at vertical
surface to mount Doestronic
controller.
The Dosetronic controller
cables need to be within
reach of the Peridoser,
sample pot and power outlet.
2. Secure Controller
Secure Dosetronic to the
wall with the self tapping
fasteners provided.
I I
I
I
I
I
I I
I I I
I
I
I
I
I
I I
Keep Dosetronic out of
direct sunlight
Mount electronic equipment such as
the Dosetronic above the sample
pot. This is because some water may
escape when the conductivity probe is
cleaned.
Avoid mounting near electrical
mains and other
powered devices