Belshaw Adamatic TG50 Thermoglaze - Manual (Page 9)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Thermoglaze 50 MN-1720WM 3
Assembly 3
Clean all parts with mild soap and water and
let dry before assembly and applying
electrical power to the equipment.
The Thermoglaze unit is design for ease of
assembly and use. The system is crated in a
manner so there are few pieces to put together
once the Thermoglaze is in place for production.
After unpacking the system per the uncrating
instructions, 1 item needs to be placed on the
Thermoglaze to finish assembly: the glaze
trough. The Glaze trough slips into the 2 holes on
either side of the drain tray with the waterfall
headed toward the oven. See figure 3-1 and 3-4
for help setting the trough in place. After the
trough is in place attach the glaze hose to the
trough by pushing it in the hose mount in the
center of the trough.
To help familiarize you with your Thermoglaze,
please study the following photographs:
Figure 3-1 Thermoglaze front view