Belshaw Adamatic EP18-24 Proofer - Manual (Page 20)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
2 MN-1203EN EP18/24/34 Econo Proofer TS
• Note: due to vibration in shipping, the
door handles might get out of adjustment.
To adjust door handles: loosen the screws
which fasten the handle to the plexiglas
door, adjust position of the handle so it
just clears the bottom of the door above
when both are closed; tighten screws. If
more than one door handle requires
adjustment, start with the one nearest the
top of the proofer and work down.
• Turn humidity control, heat control, and
control box power switch to their off
positions (see Operation Instructions)
• Connect Econo Proofer cord to power source.
Check wiring diagram and data plate for
proper power specifications.
• Mail the attached warranty registration form
within ten days of installation.
• Keep this manual for future reference. Put it
where you know you can find it.
Control Box with Auto
Water System
Remove the control box top to install the auto
water line. After installation, replace the top and
seal it with silicon seal 909-0021.F.
Initial Cleaning
Remove all the packing materials. Wipe the
Econo Proofer with a soft, damp cloth. Dry these
areas completely.
WARNING
To avoid electrocution or other injury, turn
off the machine’s main power before
attempting any cleaning, disassembly,
adjustment, or repair.