Belshaw Adamatic EP18-24 Proofer - Manual (Page 19)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
EP18/24/34 Econo Proofer TS MN-1203EN 1
1 Installation
Unpacking and Assembling
the Econo Proofer
Use a forklift to transport the shipping crate to
the workstation.
• Break down the shipping crate.
• Remove the packing materials from the
proofer, including foam, tape, brown paper,
plastic, and white protective coating.
Do not remove the plastic from the
Plexiglas doors at this time.
• Cut the bands holding the control box in
place and remove control box from cabinet.
• Remove and discard the plywood that the
control box was resting on.
• Inspect the machine to see that no parts are
bent, scratched, or otherwise damaged. If any
damage has occurred in shipping, file a
freight claim with the shipping company
immediately.
• Clean the humidifier water box and the fill
box. Refer to Section 3 for cleaning
instructions.
• Install screen rack angles onto angle supports
by tilting the angles up and sliding the flange
into the notches of the supports. See Figure 1.
WARNING
If water is spilled while cleaning the
proofer, be sure to dry the floor
thoroughly.
Figure 1
• If not already done, remove the packing
material from the control box and put water
reservoir cover in place over water reservoir.
• Place control box into cabinet, push cord
through the hole in the floor, to the left of the
control panel, and close cord opening cover
plate.
• Remove protective covering from the
Plexiglas doors. Clean the doors with warm
water.
• Insert the hinge pin on right side of door into
place, then slip the left side hinge pin onto
slot.