Belshaw Adamatic Type B Donut Cutter - Manual (Page 6)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
2 MN-1527EN Type B Donut Cutter OM
2 Cleaning
The hopper and plunger are easily removed for
cleaning purposes. Remove the hopper and
plunger as follows:
1. Be sure the plunger is in the “stop”
position so the lower piston is up in the
hopper cylinder.
WARNING
Keep your hand under the cylinder flange
at the bottom of the hopper to keep the
plunger from falling through.
2. Loosen wing nut at crown bearing and
remove crown bearing.
3. Loosen wing nut at lower clamp hinge.
4. Open hinge and pull hopper and plunger
forward. The cylinder can be removed
from the hopper. If they do not separate
readily, run hot water on the hopper and
cold water on the cylinder and try again.
CAUTION
Never put your hand in the hopper or
between trip arms while cutter is being
cranked.