Belshaw Adamatic Type B Donut Cutter - Manual (Page 22)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
6 MN-1528EN Type B Donut Cutter TS
DONUTS DO NOT DROP STRAIGHT OR SEPARATE FROM THE
CYLINDER EVENLY
Possible Causes What To Do
Machine frame out of alignment. Send to factory.
Dirty cylinder. Clean as required.
Damaged cylinder liner lip. Replace cylinder liner.
Cutter not level. Adjust mounting system.
Worn plunger pistons. Replace.
Worn cylinder liner. Replace.
UNUSUAL NOISES (CLICKING OR BANGING)
Possible Causes What To Do
Machine frame out of alignment. Send to factory.
Plunger bent. Repair or replace.
Trip arm bent. Adjust trip arm spacing. See SB-17 in
Appendix.
Upper and lower pistons straddling
cylinder. Adjust trip arm spacing. See SB-17 in
Appendix.
Dodge (drive) pin slipping. Tighten brake bands.