Belshaw Adamatic Type B Donut Cutter User Manual
Page 24
Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
8
MN-1528EN
Type B Donut Cutter TS
GOBBING (DEPOSIT OF UNWANTED DOUGH ON PRODUCT)
Possible Causes
What To Do
Worn plunger or cylinder.
Replace.
Damaged cylinder lip.
Replace.
JAMMING
Possible Causes
What To Do
Machine frame out of alignment.
Send to factory.
Plunger bent.
Repair or replace.
Trip arm bent.
Adjust trip arm spacing. See SB-17 in
Appendix.
Obstruction in cylinder.
Clear obstruction.
FRENCH CRULLER PLUNGER – STICKING OR JAMMING
Possible Causes
What To Do
Former assembly, 7B-1002, stuck or
corroded to center rod, 7B-1004.
Unscrew lower piston 7B-0003. Former
should slide off. If piston and/or former
are stuck, soak them 24 hours in light food
grade oil. Tap with soft hammer to loosen,
and then disassemble for cleaning.
FRENCH CRULLER PLUNGER – BINDING IN CYLINDER
Possible Causes
What To Do
Former bent out of alignment.
Replace former 7B-1002. Be sure to order
correct size.
FRENCH CRULLER PLUNGER – PISTON WILL NOT ROTATE
Possible Causes
What To Do
Gibs 7B-0013 sheared off.
Replace 7B-0013 gibs. (Order correct size:
7B-0013A gibs for sizes 1 1/8” and 1 ¼”;
7B-0013 for sizes 1 3/8 to 2”.