Beisler 1282-4 - Manual (Page 26)

- 17 -
Closing Seam Machine 1282-4 Working Instructions Beisler Automated Sewing Equipment
Fig. 17
Fig. 17
B.3
Operation
Controlling machine cycle in mode 01:
Mode 01 starts a combination of manually controlled
seam and subsequent automatic machine cycle that is
controlled using the pedal.
1. Insert the trousers components into the guide clamp
and line them up over the contour guide at the pres-
sure foot.
2. Pressing the right side of the pedal 2 starts the se-
wing process. The sewing speed can be controlled in
twelve stages, depending on the pressure that is exer-
ted. The higher the pressure, the faster the speed.
Using this control, the seam can be controlled manually
for complicated sewing stages.
3. The automatic machine cycle can be started by pres-
sing the left side of the pedal 1 at any position of the
seam.
• The remaining seam distance is effected along the
guide rail to the contour guide.
• The contour guide controls the further routing of
the seam.
• The sewing unit sews the overlapping compon-
ents to each other.
• The sewing process is completed as soon as the
trousers components have passed the reflective
film of the photocell.
• The puller pulls the sewing piece from the workta-
ble to the stacker.
• The stacker stacks the trousers components.
NOTE - Supplying sewing pieces!
As soon as the guide clamp has returned to the inserti-
on station, the next machine cycle can be started.