Beisler 1220-4 - Manual (Page 38)

Operating manual Automatic single head serging unit 1220/4
Page 6-14 © Beisler GmbH, Hösbach
6.3.4.2 Save setup data on the storage module
1. Select the page ‚Setup –00‘.
2. Enter the access code (see section 6.3.1).
3. Move the cursor completely to the right onto the letter ‚W‘
(= write).
4. Plug the storage module KK195 into the slot on the right
side of the operating device.
5. Press the Plus-key to copy the setup data from the control
on the storage module.
6. Press the Special-key to terminate the procedure.
6.3.4.3 Read setup data into the machine control
1. Select the page ‚Setup –00‘.
2. Enter the access code (see section 6.3.1).
3. Move the cursor completely to the right onto the letter ‚R‘
(= read).
4. Plug the storage module KK195 into the slot on the right
side of the operating module.
5. Press the Plus-key to read the setup data from the storage
module into the machine control.
6. Press the Special-key to terminate the procedure.
6.3.4.4 Copy all sewing programs on the storage module
1. Select the page ‚Index 000‘.
2. Enter the access code (see section 6.3.1).
3. Press the Special-key.
4. Plug a storage module into the slot on the right side of the
operating device.
5. Move the cursor on the letter ‚W‘ (= write).
6. Press the Plus-key to copy all sewing on the storage
module.
7. Press the Special-key to terminate the procedure.