Beisler 1220-4 - Manual (Page 30)

Operating manual Automatic single head serging unit 1220/4
Page 6-6 © Beisler GmbH, Hösbach
6.3.1 Enter machine code
ATTENTION
The machine code protects from unauthorized access to the setup
data. Wrong setup data affect the functionality of the machine
negatively. The machine code should not be accessible to un-
authorized persons.
1. Move the cursor to the program number using the keys
.
2. Press the key repeatedly, until „Setup -00“ is displayed.
3. Press the key to place the cursor on the first ‚x‘ below
the key symbol.
4. Press three times to change all ‘x’ to ‘0’.
5. Press to confirm the entered code. The key symbol
disappears.
6.3.2 Set language
If you want to work with a different operation language, you can select
this on page „Setup -00“:
1. After entering the machine code, press and select the
desired operation language using .
2. Press to place the cursor on „Setup -00“ again.
6.3.3 Adjust setup data
The setup data of this machine are contained on the pages ‘-01’, ‘-02’,
‘-03’ and ‘-10’:
Page -01: machine type
Page -02: motor functions
Page -03: machine functions
Page -10: in- and outputs (switch on/off, program)
Use the key to select the page where you want to do changes.