Beisler 100-54 - Manual (Page 41)

2-19
Error 10: fabrics inser-
ted push-back protection (photo cell
TS27) is not lighted check photo cell and foil
Error 11: switch on
vacuum before vacuum is activated with par32 =
01, but no vacuum has been
switched on before sewing switch on vacuum or select another vacuum
mode
Error 12: Vylene end vylene monitor (photo cell TS21)
detects vylene end insert new vylene roll or check photo cell
Error 13: Clamp position
error difference between must (step
motor setup) and is position (impul-
sTS from incremental Gerber) of
the clamp carriage is too large;
clamp carriage possibly blocked remove blocking part; check clamp carriage for
easy-going; check whether motor pinion is loose
on the shaft; tighten transportation belt
Error 14: Insertion/seam
length wrong insertion point rear selected; seam
length longer than the distance for
rear insertion point program lengths correctly
Error 15: Stamp not up stamp hasn’t reached home positi-
on after switching off check cylindre, valve Y20, termination switch
TS19
Error 16: Folder not
straight folder hasn’t reached middle
position within error time check cylindre, valve Y15, termination switch
TS05
Error 17: Folder not up
folder hasn’t reached
home position within error time check cylindre, valves Y24 Y25, termination
switch TS03 TS04
Error 18: Folder not
down folder hasn’t reached position within
error time check cylindre, valves Y24 Y25, termination
switch TS03 TS04
Error 19: Folder not
sloping folder hasn’t reached position
‘sloping’ (for picking up) within error
time check cylindre, valve Y15, termination switch
TS06
Error 20: Knifes not
together the movable mitre knife hasn’t
reached start position before
sewing insertion check termination switch TS20; check connection
to mitre knife motor (plug); check diodes at the
power card Berger; continue searching acc. to
diagnostics Berger motor
Error 21: Centre knife
not up centre knife hasn’t reached home
position within error time check cylindre, valves Y03 Y48, termination
switch TS13
Error 22: Front mitre
knifes not down front mitre knifes (seam end)
haven’t reached home position
within error time check cylindre, valve Y04, termination switch
TS19
Error 23: Rear mitre
knifes not down rear mitre knifes (seam start)
haven’t reached home position
within error time check cylindre, valve Y04, termination switch
TS18
Error 24: Scissor not up scissor hasn’t reached home
position within error time check cylindre, valves Y21 Y22, termination
switch TS14
Error 25: Scissor not
down scissor hasn’t reached cutting
position within error time check cylindre, valves Y21 Y22, termination
switch TS15
Error 26: Pinole not up the pinole for piping turning hasn’t
reached upper position within error
time check cylindre, valve Y59, termination switch
TS41