Beisler 100-54 - Manual (Page 33)

2-11
32 Vacuum mode (option)
00:
vacuum disabled
01: vacuum on with foot pedal vacuum (with display ‘enable
vacuum’ if not enabled with foot pedal)
02:
vacuum on automatically if main clamp at insertion position
03: vacuum on with foot pedal advance
33 Main clamp mode
00:
main clamp left/right down and tight
01: main clamp left down and tigh
02: main clamp right down and tight
03: main clamp both weak, before insertion both tight
04: main clamp laterally
34 Piping cutting / Marking lamp mode
00:
switched off
01: front positioning point
02: rear positioning point
03: middle position
35 Stacker mode
01:
only final roller
02: only folding stacker
03: folding stacker and final roller
36 Push-back locking off
00:
Push-back locking enabled
01: Push-back locking disabled
37 Folder as stamp [00] (00 - 01)
00:
normal insertion process enabled
01: with the first step on the foot pedal, the folder is lowered and
fixes the work piece; next step drives main clamp to insertion position;
after clamp is closed, the folder is pushed up to allow the insertion of
the vylene; only required for trouser production with pocket automaton
100/55/56 without stamp
38 Flap clamp mode
00:
flap clamp active with foot pedal only
01: flap clamp active automatically
39 Breast welt mode
The breast welt swings in together with the flap station; then is the
01:
left main clamp loose
02: both main clamps loose
3.3.1 Seam parameter 30: Flap clamp mode
In the control, you can switch on/off the left or right flap clamp and select one
of eight modes additionally; dependant on the selection, the flap clamp
behave different. In the following table, the mode number is shown in the first
column, the behaviour of the flap clamps is indicated with graphics.
left clamp closed
right clamp closed
left clamp open
right clamp open