Beisler 100-54 - Manual (Page 16)

1-14
If the black grip (1) stands at the front (closer to the operator), the piping
slitting device is set to double-piping. If the grip stands in the back (closer to
the sewing head), it is set to strip.
Use the tilt switch (2) to switch on/off the piping slitting device. If the switch is
in the upper position, the device is switched on, in the lower position, the
device is switched off.
4.1.8 Take off roller
After mitre cutting, the take off roller brings the fabrics into the desired
stacking position.
4.1.9 Flap station with flap feeding device
This swings the inserted flap (or the pocket pouch) under the clamp.
4.1.10 Swing out insertion station
100-55 100-56
For several reasons (e.g manual spooling) the insertion station must be
swung out to give access to the sewing head.
Grasp the insertion station as shown in the picture and pull it out of the
locking (A). When swinging in, be sure that the insertion station is inserted
completely into the locking.
Attention
The folder and the lamps of the crosshair attached to it are adjusted exactly
and are sensitive against violence. Therefore, swing the folder slowly and
without the use of power.