Denon AVR-1603 - Manual (Page 22)

22
ENGLISH
Use the (left) and (right) buttons to set the delay time.
DELAY 30ms
110ms 30ms 0ms
(Remote control unit)
(right) button (left) button
(3) DELAY TIME
(Initial)
Use the (left) and (right) buttons to set the D. COMP.
D.COMP. OFF
OFF LOW MID HI
(Remote control unit)
(right) button (left) button
(4) D. COMP.
(Initial)
Use the (left) and (right) buttons to set the LFE level.
LFE 0dB
-10dB 0dB
(Remote control unit)
(right) button (left) button
(5) LFE
(Initial)
NOTE: This parameter is displayed during DOLBY DIGITAL playback.
NOTE: This parameter is displayed during DOLBY DIGITAL and DTS playback.
To reset the settings to the factory defaults, use the (left) and (right)
buttons to display “Yes”.
DEFAULT Y/N
NO Y/N YES
(Remote control unit)
(right) button (left) button
(6) DEFAULT
• Operating the surround mode and surround parameters from the main unit‘s panel.
1 Turn the SELECT knob to select the surround
mode.
(Main unit)
• When turned clockwise
DIRECT STEREO DOLBY PRO LOGIC II 5CH STEREO MONO MOVIE
JAZZ CLUB ROCK ARENA VIDEO GAME MATRIX VIRTUAL SURROUND
DIRECT STEREO DOLBY PRO LOGIC II 5CH STEREO MONO MOVIE
JAZZ CLUB ROCK ARENA VIDEO GAME MATRIX VIRTUAL SURROUND
• When turned counterclockwise
To select the surround mode while adjusting the surround parameters, channel volume or tone control,
press the SURROUND MODE button then operate the selector.
(Main unit)
1, 3 2 1
2 Press the SURROUND PARAMETER button.
Press and hold in the surround parameter button to select the parameter you want to set.
• The parameters which can be set differ for the different surround modes. (Refer to “Surround Modes and
Parameters” on page 23.)
(Main unit)
3 Display the parameter you want to adjust, then turn the SELECT knob to set it.
NOTE:
• When playing PCM digital signals or analog signals in the 5CH STEREO, ROCK ARENA, JAZZ CLUB, VIDEO
GAME, MONO MOVIE or MATRIX surround modes and the input signal switches to a digital signal encoded
in Dolby Digital, the Dolby surround mode switches automatically. When the input signal switches to a DTS
signal, the mode automatically switches to DTS surround.
Surround parameters e
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small), “medium”, “med.l” (medium-large) and “large”.
“small” recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 110 ms.
4 Press the ENTER button to finish surround parameter mode.
(Remote control unit)