Denon AVR-1603 - Manual (Page 10)

10
Check that all the components are correct, then press the POWER operation
switch on the main unit to turn on the power.
Press the SYSTEM SETUP button to enter the setting.
Press the ENTER or (down) button to switch to the speaker
configuration set up.
NOTE:
Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time. The
changes to the settings made up to that point are entered.
1
2
3
*SYSTEM SET UP
Before setting up the system
NOTE: Please make sure the “AUDIO” position of the slide switch on the
remote control unit.
(Main unit)
Use the (left) and (right) buttons to select your center speaker type.
Press the ENTER or (down) button to switch to the surround speaker setting.
2 CENTER SMALL
LARGE SMALL NONE
NOTE:
• When “Small” has been selected for the front speakers, “Large” cannot be selected for the center speaker.
Use the (left) and (right) buttons to select your surround speaker type.
3
2
Press the ENTER or (down) button to switch to the subwoofer setting.
3 SURR. SMALL
LARGE SMALL NONE
NOTE:
• When “Small” has been selected for the front speakers, “Large” cannot be selected for the surround speakers.
Setting the speaker configuration
Use the (left) and (right) buttons to select your front speaker type.
Press the ENTER or (down) button to switch to the center speaker setting.
1 FRONT LARGE
LARGE SMALL
(right) button (left) button
1
(right) button (left) button
(right) button (left) button
(Initial)
(Initial)
(Initial)
ENGLISH
Use the (left) and (right) buttons to select your subwoofer setting.
4
Press the ENTER or (down) button to enter the settings and switch to the
SUBWOOFER MODE setting.
4 S.WOOFER YES
YES NO
• Parameters
Large…… Select this when using speakers that can fully reproduce low sounds of below 80 Hz.
Small…… Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient
volume. When this setting is selected, low frequencies of below 80 Hz are assigned to the subwoofer.
None…… Select this when no speakers are installed.
Yes/No…. Select “Yes” when a subwoofer is installed, “No” when it’s not installed.
NOTE:
Select “Large” or “Small” not according to the physical size of the speaker, but according to the bass reproduction
capacity at 80 Hz. If you cannot determine the best setting, try comparing the sound when set to “Small” and
when set to “Large”, at a level that will not damage the speakers.
Caution:
In case the subwoofer is not used, be sure to set “Subwoofer = No”, or the bass sound of front channel is divided
to subwoofer channel and not reproduced in some mode.
(right) button (left) button
(Initial)
Setting the Subwoofer mode and Crossover Frequency
Use the (left) and (right) buttons to select the Subwoofer mode.
Press the ENTER or (down) button to enter the setting and switch to the
Crossover Frequency setting.
5 SW MODE NORM
+MAIN NORM
(right) button (left) button
1
(Initial)
Use the (left) and (right) buttons to select the Crossover Frequency.
Press the ENTER or (down) button to enter the setting and switch to the
SPEAKER DISTANCE setting.
6 CR.OVER 80Hz
80Hz 100Hz 120Hz
(right) button (left) button
2
(Initial)