BDI 9950 Vista - Manual (Page 2)

2
assembly instructions
bdiusa . com customerservice @ bdiusa . com
3
Step 5
Install glass shelves.
First, position Glass Shelf (O) so that discs are
resting on the ends of the Shelf Brackets (N).
Keeping one hand on the shelf, pick up one M8 x
1.5” Flat Head Socket Screw (P) and thread up
through the bottom of the cylinder into the hole
on the bottom of the glass mounting disc. Thread
second screw into second disc. Using Small Hex
Wrench, fully tighten both left and right discs.
Step 2
Attach Glides
Thread Adjustable Glides (B) into holes on underside
of Base (A) (Figure 1).
Step 3
Attach Spine
Attach Spine (D) to Base (A) using 4 - 3/8 x 1.25”
Flat Head Screws (E) and Large Hex Wrench
provided (Figure 1).
Figure 4
Step 5
Attach Shelf & Screen Brackets
Attach Shelf (N) & Screen Brackets (HTR, HTL,
HBR, HBL) as shown with 3/4” Pan Head Screws
(I) (Figure 3) using Large Hex Wrench. Slots on the
face of the screen brackets should face forward.
Screen brackets may need to be adjusted up or
down to align with horizontal bars.
O - Shelves
x 2
P x 4
Figure 3
I x 16
HTL
N - Shelf Brackets
2 Left & 2 Right
HBL
HTR
HBR
Figure 1
B - Adjustable
Glides x 5
E x 4
A - Base
D - Spine
Step 4
Attach Front Cover Panel
Install Front Cover Panel (F) to front of spine using
5/8” Long Phillips Head Screw (G) as shown (Figure
2). Bottom end of cover panel is attached with hook
and loop pads. Note: The front cover panel has a
flatter curve. Back panel has a notch at the bottom.
G x 1
FF - Front
Panel x 1
Figure 2
Note: Each shelf
will support up to
50 lbs (23 kg).