BDI 6006 Sequel - Manual (Page 2)

2
assembly instrUCtions
bdiUsa . Com CUstomerserviCe @ bdiUsa . Com
Reverse Door-Swing (if desired)
Sequel features a reversible door assembly so that
you can open either from the left or the right.
To reverse the door’s orientation,
Remove the Door by actuating both of 1.
its quick-release hinges; carefully place the
detached Door aside.
Using a Philips head screwdriver, remove 2.
both Hinge Plates from the interior wall of the
cabinet by loosening the screws holding it in
place.
Install both Hinge Plates to the opposite 3.
interior wall at the pre-determined locations.
Re-install the Door by connecting each Door 4.
Hinge to the relocated Hinge Plates.
1.
2.
3.
3.
1.
2.*
2.*
Adjust Door Hinges (if needed)
If the cabinet’s door appears out of alignment, this can be corrected with minor adjustment to the European
hinges on each door.
Because these hinges are infinitely adjustable, adjusting one hinge element can sometimes cause the need for
adjustments to other elements. But with a few adjustments, you can modify the orientation of the cabinet door
to make sure that it hangs evenly.
Use a Phillips screwdriver to adjust Sequel’s door
hinges:
By adjusting
•
Screw 1, the door will move
LEFT or RIGHT within the frame. Make minor
adjustments at both top and bottom hinges for
best results.
By adjusting
•
Screw(s) 2, the door will move
UP or DOWN within the frame (the top and
bottom hinges must be adjusted the same
degree).
NOTE: Loosen Screws 2 one complete turn,
raise or lower door, then hold in position
while tightening Screws 2 (on both hinges).
By adjusting
•
Screw 3 the entire door will
move IN or OUT, opening or closing the gap
between the door frame and cabinet. (This
screw rarely needs adjustment.)
Step 3
Install Back Panel
Install Back Panel (E) to the backside of the cabinet by
first inserting the panel into the cabinet then raising it up
and down in to the grooves.