BDI 6006 Sequel - Manual

1
B - 5/32” x 12mm
Phillips Screw x 16
S
equel
6006 CPU
Cabinet
a s s e m b l y i n s t r U C t i o n s
bdiUsa
.
Com CUstomerserviCe
@
bdiUsa
.
Com
Your Sequel Home Office Furniture is engineered for easy assembly.
Carefully follow this procedure to prevent any damage.
Placement and Maintenance
Sequel Home Office Furniture is designed for indoor use on level floors.
Clean steel parts and wood veneer with a moist cloth.
Step 1
Unpack and Identify
Unpack and identify the components at left. Note that some components
are shipped inside the cabinet. The assembly workspace should be a non-
marring surface such as carpet. A Phillips Screwdriver will be needed for
assembly. For missing hardware pieces, please contact BDI Customer
Service at [email protected]. For all other concerns, please
contact your BDI Retailer.
Step 2
Install Casters
Carefully position CPU Cabinet (A) on its top surface so that bottom
surface is up, then attach a Brake Caster (C) and Rear Caster (D) at
each of the four (4) exposed installation plates using 5/32” x 12mm
Phillips Screw (B) and a Phillips Screwdriver.
Component List
D - Rear Caster x 2
C - Brake Caster x 2
E - Back Panel x 1
A - CPU Cabine t x 1
Designed by Matthew Weatherly.
‘Sequel’ is a trademark of Becker Designed, Inc.
All rights reserved. ©2009 Becker Designed, Inc.
Made in Taiwan. 6006REV121509v2
FRONT
B x 8
B x 8
C x 2
D x 2
6001 6002 6005 5 6 6 6006 6007 7 6