BDI 9221 VEXA - Manual (Page 5)

ATTENTION
VEXA is intended for table top rear projection and flat panel TV's.
This unit is NOT intended for CRT TV's.
If rear projection is used on VEXA, TV must be positioned as far back as possible.
Minimum 1" (25mm) from front edge of frame.
Position of flat panel TV too
close to the front edge of the
frame is not recommended.
Not Acceptable
Position of flat panel
TV behind frame is
recommended.
Side view of VEXA TV stand Side view of VEXA TV stand
Flat panel TV
illustrated
Rear projection
TV illustrated
Acceptable:
TV positioned minimum
of 1" from front edge of
frame
Minimum
of 1"