BDI 1542 Crease - Manual (Page 2)

2
assembly instructions
bdiusa . com customerservice @ bdiusa . com
crease
1542 1546 1548 1549
Step 3
Attach Wood Shelf
With a second person holding the Wood Shelf (E) in place, loosely start all Screws (B).
Step 4
Align Wood Shelf & Turn Table Over
Align the corners of the Wood Shelf (E) with the Leg (C). Once aligned, tighten Screws
(B) using Hex Wrench (A). With the help of a second person, turn table over right side
up, lifting by the table’s Legs (C), .
Step 5
Remove Glass Spacers
Before removing the Glass Spacers (F), make sure there is consistent spacing
between the Legs (C) and the Glass Top (D) as illustrated in Fig. 1A. If necessary,
slightly loosen the misaligned end and adjust the Leg (C) so the Removable Glass
Spacers (F) are pressing against the edge of the Glass Top (D) and re-tighten
screws. Once the table is properly aligned, remove the 4 Glass Spacers (F) by sliding
them upward off the Legs (C) as illustrated in Fig. 2.
Crease 1548 Console Table Only
B
B
B
E
E
Correct Incorrect
E
E
C
C
Aligned
Not Aligned
C
D D
C
Fig. 1A Fig. 1B
Aligned
Not
Aligned
Fig. 2