Basler Electric MVC300 - Manual (Page 13)

4-1
A periodic inspection should be made of the unit to insure it is clean and free from accumulations of
dust and moisture. Verify that all terminal connections of the MVC-300 and the voltage regulator
are tight.
In the event of failure/defective operation of the unit, Table 4-2 provides information to determine the
probable cause of the malfunction and the solution. Refer to Paragraph 3-3 and to Figure 3-4 for
the bench test procedure.
Due to a protective coating, repair/replacement of individual components on the printed circuit board
assembly should not be attempted and the complete replacement of the board is recommended.
When ordering replacement parts from Basler Electric always specify the part number, the quantity
and the description of the item.
Table 4-1. Replacement Parts List.
Reference
Designator
Part
Number Quantity
Description
---------------- 9 1210 01 103 1 Printed Circuit Board Assembly
F1,F2 04592 2 Fuse, 10 A, 250 V
SECTION 4
MAINTENANCE AND TROUBLESHOOTING
4-1. PREVENTIVE MAINTENAN CE
4-2. TROUBLESHOOTING
4-3. RECOMMENDED SPARE PARTS