Basler Electric BE1-40Q - Manual (Page 12)

SPECIFICATIONS
BE1-40Q electrical and physical specifications are listed in the following paragraphs.
Current Sensing
Unit is designed to operate from the secondary of a standard current transformer rated at 5 A, 50 and 60
Hz (based on configuration). Internal current sensing transformers are rated at 10 A continuous, 15 A for
1 minute, and 200 A for 1 second.
Current Sensing Burden
Maximum sensing burden is less than 0.1 ohm at pickup over the frequency range of 45 to 65 Hz.
Voltage Sensing
Three line-to-line voltage sensing inputs are available: 120, 208, and 240 Vac (nominal). Each have a
burden that is less than 1 VA over the frequency range of 45 to 65 Hz.
Pickup Range
Refer to Table 1-1.
Table 1-1. Pickup Ranges
Sensing Input
Range
Tap A B C D E F G H J K
2
120 Vac
HI 20 40 60 80 100 120 140 160 180 200
LOW 5.0 10 15 20 25 30 35 40 45 50
3
120 Vac
HI 100 200 300 400 500 600 700 800 900 1000
LOW 25 50 75 100 125 150 175 200 225 250
5
208 Vac
HI 40 80 120 160 200 240 280 320 360 400
LOW 10 20 30 40 50 60 70 80 90 100
6
208 Vac
HI 200 400 600 800 1000 1200 1400 1600 1800 2000
LOW 50 100 150 200 250 300 350 400 450 500
8
240 Vac
HI 40 80 120 160 200 240 280 320 360 400
LOW 10 20 30 40 50 60 70 80 90 100
9
240 Vac
HI 200 400 600 800 1000 1200 1400 1600 1800 2000
LOW 50 100 150 200 250 300 350 400 450 500
Pickup Accuracy
±2% of the front panel setting or ±0.1 var, whichever is greater for a power factor angle of –90°.
Dropout
Not less than 95% of actual pickup.
Time Delay Range
Definite time delay is adjustable by two front panel thumbwheels over a range of 01 to 99 (0.1 to 9.9
seconds) in increments of 0.1 seconds. A setting of 00 enables instantaneous operation.
Timing Accuracy
Shown in Figure 1-5. Note that each curve is slightly offset by a factor that represents integration time.
Repeatability is within
±5% or 25 milliseconds, whichever is greater.
1-4 BE1-40Q General Information 9171500990 Rev N