Balanced Audio REX II Preamplifier - Manual (Page 9)

9
Stacking the modules (putting the Control Module on top of
the Power Module) is NOT permitted.
CONFIGURING THE REX II PREAMPLIFIER SYSTEM
The REX II preamplifier system consists of two modules.
Control Module performs all the control functions associated with the
duties of the preamplifier in your system. It also receives and processes the
remote control commands.
Power Module works in conjunction with the Control Module as an outboard
power supply.
The two modules are connected by two detachable cables. In addition each module
has its own power cord that must be plugged into the power outlet.
WARNING
Make sure your REX II is powered DOWN before making or
changing ANY connections between its two modules, to the
source components or power amplifiers.
Connect the two detachable cables between the modules, making sure the channels
are connected properly.
Plug the two power cords into power receptacles.
Make all the signal connections.
CONNECTING THE REX II TO YOUR SYSTEM
Balanced Components
Use balanced XLR interconnects. All input and output connectors are clearly
marked on the back panel.
Note: The REX II XLR connectors are wired as follows: