Balanced Audio REX II Preamplifier - Manual (Page 15)

15
and Volume knob, or corresponding remote control buttons (Function and Volume
Up/Down buttons).
Every unit comes from the factory with a default set of parameters stored in its
memory. This set of parameters is usable for many applications. The default set
includes the following parameters:
BALANCE ZERO
RELATIVE VOLUME ZERO
PHASE Non-Inverting
MONO/STEREO STEREO
MAXIMUM VOLUME 140
FIXED GAIN OFF
DISPLAY COUNTS
INPUT NAMES 1 TAPE
2 TUN
3 CD1
4 AUX1
5 AUX2 or PH1 if the phono card is
installed
The user may at any time, configure the unit to a particular set of system
requirements. For example, input names can be changed to reflect a given
system’s source configuration.
Parameter Definitions:
Every input of the REX II is defined with the following set of parameters.