Balanced Audio REX II Preamplifier - Manual (Page 13)

13
2. Four-character input name. That name is fully programmable (See the
programming functions) and can include up to four character from the Latin,
Cyrillic or Greek alphabets or digits.
3. Balance adjustment indicator. Characters L or R indicate that the balance is
shifted in the corresponding direction. A BLANK character means that the
gains of both channels are identical.
4. Volume setting - three digits with the full range of 000 to 140 (See
programming section on Maximum Volume Setting)
FUNCTION Button
This button puts the unit in its programming mode. In addition to its normal PLAY
mode, there are eight programmable functions in the REX II:
BALANCE Adjustment
RELATIVE VOLUME setting
PHASE setting
MONO/STEREO setting
MAXIMUM volume setting
FIXED volume setting
DISPLAY (Volume) mode
INPUT NAME assignment
Pressing this button while in PLAY mode will switch the unit into programming
mode. Once in the programming mode, pressing the Function button will switch the
unit into its NEXT programmable functions. The unit will stay in the programming
mode until the exit command is issued. To EXIT the programming mode at any
time, press and hold the Function button for about TWO seconds.
DISPLAY Brightness Function
Changing the Display Brightness: The REX II display can be dimmed or
turned completely OFF by simply pressing the DISPLAY button on your VK-R3
remote control transmitter.
Each press will reduce the brightness of display and LED indicators in steps
from full ON to OFF, and then one press back to full ON. The LED indicators