Balanced Audio REX II Preamplifier - Manual (Page 22)

22
When the FADE button is pressed, the volume will go down all the way to zero (000
on display, unit in Mute).
Pressing the Fade button again will cause the volume to ramp back up to its initial
value.
INPUT SELECT:
Pressing any input selection button on the VK-R3 remote control will switch the REX
II to that input. All of the set parameters associated with that input will be loaded
at this point.
DISPLAY/POWER switch.
The Display/Power button on the VK-R3 remote control provides two functions:
turning the REX II display ON/OFF and switching the power to the preamplifier.
To control the display:
Pressing the display button will change the display brightness.
Turning the REX II OFF
With the display in ON state, press and hold the Display button on the VK-R3
remote control. This function is disabled when the unit’s display is turned
OFF.
Turning the REX II ON
With the REX II in its OFF or STANDBY state, simply press the POWER button
on the VK-R3 remote control transmitter.
Fuse Protection:
A blown fuse in the REX II is an indication of a serious problem. If a replacement
fuse fails as well, no further attempts should be undertaken. Please contact the
factory for professional service.
The proper fuse ratings are as follows:
For 100-120 VAC Units: 2A 250V Slow Blow
For 200-240 VAC Units: 1.5A 250V Slow Blow