Balanced Audio REX II Preamplifier - Manual (Page 18)

18
PHASE programming.
Select the desired input.
Press the Function button three times. The display will read: PHASE NINV.
Use the volume knob to set the condition to NINV, INV or LAST.
Exit the programming mode by pressing and holding the Function
button .
NOTE: In the LAST mode, the state of the PHASE switch will be the
same as used the last time for that particular input.
MONO/STEREO programming.
Select the desired input.
Press the Function button four times. The display will read: STEREO
Use the volume knob to set the condition to STEREO, MONO or LAST.
Exit the programming mode by pressing and holding the Function
button .
NOTE: In the LAST mode, the state of the Phase switch will be the
same as used the last time for that particular input.
MAXIMUM gain programming
It may be desirable to limit the allowable volume setting on a particular input. To
do this:
Select the desired input
Enter the MAXIMUM programming mode by pressing the Function button five
times.
Set the display to any desired number that will now represent the maximum
allowable volume setting for the selected input.
Exit the programming mode by pressing and holding the Function
button .