Baby Lock Ellegante 3 (BLG3) Instruction and Reference Guide Addendum - Manual (Page 33)

31
E
NGLIS
H
About the Circular Attachment
This device can sew circular patterns that graduate out at 5mm intervals, ranging from 30mm to 130mm in
radius* when the center needle position is selected. The device is set to the left of the needle on your sewing
machine. Utility and decorative stitches can both be sewn using this device.
* Radius= Distance from center of circle to any point on the circle.
Included Accessories
Note
• You cannot use any decorative stitch with side feeding, or stitches over 7.0 mm in width. Use fabrics with a thickness of
less than 4mm (approx. 3/16”).
CAUTION
• Special care is required for the pivot pin; Neglectful treatment may cause injury. Young children should
be supervised to ensure that they do not play with the attachment. When attachment is not in use, always
keep the pivot pin in the indicator to avoid its loss.
1
2 3
4 Conversion Chart
mm ( f ) inch
130 5 3/16
120 4 3/4
110 4 3/8
100 4
90 3 1/2
80 3 3/16
70 2 3/4
60 2 3/8
50 2
40 3/2
30 13/16
5 6
No. Part Name Part Code
1 Circular Attachment
a Indicator
b Handle/Flips Up
c Release button
d Setting position for pivot pin
e Scale
BL-CSA
2 Pivot Pin XE6016-001
3 Attachment Screw
(2pcs. one is extra) XE6022-001
4 Template
f Radius of circle in mm
g Angular lines listed in degrees
starting at 0 with 5 degree
intervals
h Center
XE6024-001
5 Braiding Foot XE5980-001
6 Cording Foot XA6871-001
Note
• We recommend that you use the extension table on
your sewing machine for smooth fabric control.
• Do not raise the extension table when the circular
devise is attached.
• The pivot pin may be released if you hold up the
fabric while attached to the circular attachment.
When holding up the fabric gently press down on the
top of the pivot pin.
• When sewing smaller circles or using fabric with a
grain or uneven textures, a perfect circle may not be
achieved.
• Some of presser feet such as the side cutter cannot
be used with this attachment, always test your
accessory feet with the attachment.
• When using this attachment test the sewing speed
of your machine for the best results.
• When sewing larger pieces of fabric or garments,
make sure that your fabric or garment does not get
caught on the machine creating drag or distortion of
your design.