Avery Dennison 9450 RASCAL Wall Chart - Manual (Page 3)

LOADING SUPPLY
1. Remove the supply holder from the
supply well.
2. Push the printhead lever up, to open
the printhead.
3. Slide the supply roll onto the spindle
and into the supply well.
4. Push the roll of supply against the
back of the well.
5. Insert the leading edge of the supply
into the supply guide and out the
printer.
6. Place the supply holder on the spindle
to hold the supply in place. Make sure
the supply turns freely in the well.
7. Push the printhead lever down to
close the printhead.
• If the printer is turned on, the
supply feeds through the supply
chute automatically.
• If the printer is turned off, turn the
knob clockwise to feed the supply
through the supply chute.
9 4 5 0

P r i n t e r
Supply
Chute
Supply
Holder
Knob
Printhead
Lever
Supply
Guide
Supply
Well
Spindle