Avery Dennison 9401 Setup Guide - Manual (Page 4)

NOTE: The keyboard cable is marked with the word "TOP" to
help you connect it to the printer.
4. Connect the power cord to the socket as shown. Plug the
other end of the cord into a grounded 110VAC electrical
outlet.
Printing Test Tags and Labels
You can print test tags or labels to see if your printer is working
properly. Your printer should arrive with a strip of blank supply
loaded for you (if this supply has been used or discarded, refer
to your
Equipment Manual for instructions on loading supplies).
To print a test tag or label, perform the following procedure:
1. To turn the printer On, press the top of the power switch
On the back of the printer.
2. You’ll see a copyright message, then
Calibrating...
as the printer checks the supply. You’ll see another
message as the printer loads formats. Then you’ll see
PRINT MODE
Ready
3. Press
8
. You’ll see
MAIN MENU
< Print Mode >
9401/9402 Read This First
1-4