Avery Dennison FreshMarx 9417 Replacing the Printhead - Manual (Page 3)

Replacing the Printhead 3
8. Open the four black flex connector latches. Remove the flex from the flex connector
9. t
Flex Connectors
Flex Connector Latch
Note: Apply careful, even pressure on the latches when opening and closing.
Lift out he printhead assembly.
I n s t a l l i n g t h e P r i n t h e a d
1. Make sure the four black flex connector latches are open, then insert the printhead flex into the
on the latches when opening and closing.
3. e
flex connector. Make sure the flex is inserted all the way into the connector.
2. Close all four of the black flex connector latches.
Note: Apply careful, even pressure
Lay th printhead assembly into place.