Avalon Firestyles 900 PI-1993 to 1996 - Manual (Page 29)

O
PERATING
Y
OUR
H
EATER
(C
ONTINUED
)
P AGE 29
L OCATION OF C ONTROLS - S EE E XPLANATION B ELOW
START
OFF
POWER
ON
HIGH OFF
BURN RATE
LOW
HIGH LOW
FAN
START
OFF
POWER
ON
HIGH OFF
BURN RATE
LOW
HIGH LOW
FAN
AIR CONTROL
Knob
900 PS Pellet Stove
900 PI Pellet Insert
OPERATING
Light
POWER Switch This control is used to turn the stove on and off.
WARNING: Do not unplug the heater to turn it off. This heater relies upon
electricity to push the flue gases out the pellet vent Ð unplugging it
may lead to smoke in your room.
OPERATING Light This light indicates that the stove is in operation. It will not turn on until the
POWER switch is on and the START switch is pressed. It will not turn off
until the POWER switch is turned off and the heater has cooled off.
START Switch This control starts the heater. It will need to be pressed each time the heater
is re-started.
BURN RATE Dial This dial controls the amount of pellets that are fed into the firepot and
hence the amount of heat. This dial must be used in conjunction with the
A
IR C ONTROL to operate the heater correctly.
HINT: Adjust the B URN R ATE and A IR C ONTROL together. The higher the
B URN R ATE the farther out the A IR C ONTROL should be.
FAN Dial This dial controls the amount of heated air that is blown out of the heat
exchange tubes above the door. Generally, the higher the B
URN R ATE the
higher the FAN dial should be set.
A IR C ONTROL Knob This controls the amount of air entering the firepot (see the Hint above).
Out is more air, in is less air.