Installation, For qualified installers only) – Avalon Firestyles 1080 CF Installation User Manual

Page 21

Installation

(for qualified installers only)

4090807

100-01193_003

3. Determine a location for the single-gang junction box that contains the battery pack and

wireless wall switch. It must be located within 12’ of the DCMD and battery pack wires that lead
to the gas control valve and receiver module on the fireplace (see Figure 11). Mount the
junction box.

4. Insert the DCMD and battery pack wires through the junction box, leaving approximately 8” of

slack so the battery pack may be removed and the batteries replaced. Use a staple or other
means to secure the wiring to the framing – this prevents the wires from slipping out of the
junction box in the event the wires become disconnected from the battery pack (see Figure 11).
NOTE: The wiring is low-voltage (6V) and does not require a strain relief. Connect the DCMD
and battery pack wires to the battery pack (see Figure 13).

PRESS TO OPEN

The red wire goes to

the third slot, the

black wire to the

fourth (lowest) slot.

The DCMD wires are secured to the

terminal block with these screws.

Connect the battery box wiring

harness to this connector.

Back of Battery Box

Battery Box Wiring Harness

DCMD Wires

Figure 13

NOTE: You may wish to install the wireless wall switch (and cover plate) after the drywall has been
installed. Remember to mask off this area prior to drywall installation.

5. Make sure the battery box is switched to “DC Motor Drive”. Place the battery pack inside the

junction box. Attach the wireless wall switch to the junction box with the included screws.
Attach the cover plate to finalize the wall plate installation.

Battery Pack

Make sure this

switch is set to

"DC Motor Drive"

Cover Plate

(snaps into place)

PRESS TO OPEN

Latching Solenoid DC Motor Drive

Wireless Wall Switch

(includes two "CR2032" 3V batteries)

Secure to the junction box with the two

included screws.

Leave approximately 8" of slack in the wire

so the battery pack can be removed and the

batteries changed.

Junction Box (single gang)

Staple the two wires near the

junction box. This prevents the

wires from slipping out of the

junction box while the batteries

are replaced.

Figure 14